elecfreaksElecfreaks· Cartes & informatique embarquée
ELECFREAKS Octopus 3V Laser Sensor
Réf. fabricant EF04096
3.90 $≈ 3.38 €
Réf. fabricant EF04096
Vendu par elecfreaks à 3.38 €. Livré en France, port, TVA et droits de douane éventuels compris, il revient à environ 22.06 €. Prix relevés le 2026-09-16.
Le coût livré est une estimation pour un article seul expédié en France métropolitaine ; seul le panier du vendeur fait foi.
| Article | 3.38 € |
|---|---|
| Frais de port | 15.00 € |
| TVA (20 %) | 3.68 € |
| Total livré | 22.06 € |
Estimation pour un article seul livré en France métropolitaine, expédié hors UE : des droits de douane et frais de dédouanement peuvent s'ajouter, facturés par le transporteur.
| Tension | 3 V |
| Poids | 16 g |
ELECFREAKS Octopus 3V Laser Sensor is the laser emission electric brick in our Octopus series, the basic design is from the Octopus electric bricks, and the setting of its outlook, the PCB fixing hole, and the connectors are the same. It is made of a laser emission chip, condensing lens, and an adjustable sleeve, which can work after powering on. Notice: Please do not shine the eyes. The laser emits a red laser beam that usually can be seen as a red dot, but you can only see a slight red line under the condition of a frog or another medium. CHARACTERISTICS The emitting principle of the laser and its special emitting process make the laser equip the features that normal light does not have: "The Three Goods" (Good monochromaticity, good coherence, and good directionality ) and "One High" (High brightness) Support micro:bit in 3V. Easy and convenient for connection SPECIFICATION Items Parameters Name Octopus 3V laser sensor SKU EF04096 Working Voltage DC 3~5.5V Wave Length 650NM Rate of Work 5MW Spot Size φ10mm ~ φ15mm(15 meters away) Connection Mode G-GND, V-VCC, S-signal pin Size 38.9x23.5mm Net weight 5g CONNECTION DIAGRAM Connect the module with the wire(with buckle) to the PI pins on the Octopus:bit, and insert the micro:bit to the Octopus:bit. PROGRAMMING Program in the makecode and write high level to P1 port to make the laser on and low level to make the laser off. Links You can also download it directly: RESULTS The laser lights are on.
