radiomasterRadioMaster· Capteurs
MT12 Gyro Control Module
Réf. fabricant HP0157.MT12-0047
9.99 $≈ 8.70 €
Le prix en résumé
Vendu par radiomaster à 8.70 €. Livré en France, port, TVA et droits de douane éventuels compris, il revient à environ 28.44 €. Prix relevés le 2026-09-18.
Le coût livré est une estimation pour un article seul expédié en France métropolitaine ; seul le panier du vendeur fait foi.
Disponibilité inconnue
Coût total livré estimé
| Article | 8.70 € |
|---|---|
| Frais de port | 15.00 € |
| TVA (20 %) | 4.74 € |
| Total livré | 28.44 € |
Estimation pour un article seul livré en France métropolitaine, expédié hors UE : des droits de douane et frais de dédouanement peuvent s'ajouter, facturés par le transporteur.
Historique de prix
2 relevés de prix/stock depuis le 20/08/2026
Caractéristiques (extraites automatiquement)
Mécanique
| Poids | 150 g |
Description
The MT12 gyro enables control of two channels using hand gestures, allowing you to operate devices such as a pan/tilt gimbal, RC tank turret, rear wheel steering, and more. When installed in the MT12 expansion slot, this two-axis gyro integrates your hand movements into the control stream through the advanced mixing and programmability of EdgeTX. The only limit is your imagination! Specifications Power Supply: DC 3.3V Weight: 8.3g Dimensions: 65.0*33.0 mm X-axis Angle Range: 90° [-45° to 45°] Y-axis Angle Range: 90° [-45° to 45°] Installation Remove the battery from the bottom of the MT12 Remove the top cover from the MT12 by pushing away from the grip Install the Gyro module at the top of the radio base Plug the cable into the 5pin connector in the battery compartment How to use Settings related to MT12 Radio 1. Press the “SYS” button and use the “PAGE” button to navigate to the “HARDWARE” menu. Set “S3” and “S4” under “Pots” to “Axis X” and “Axis Y”, respectively, as shown in the diagram below: *Arrows behind Axis X and Axis Y represent the direction settings. After selecting with the scroll wheel, you can press the scroll wheel to modify the direction. 2. Calibration in MT12. Press the “SYS” button and use the “PAGE” button to navigate to the “HARDWARE” menu. Enter the “[Calibration]” menu to calibrate. The calibration method is the same as the process for calibrating other inputs on MT12. At the “SET AXIS MIDPOINT” step, place the MT12 on a table and keep it level, then press the scroll wheel to calibrate the neutral point. At the “MOVE AXIS/POTS” step, in addition to calibrating the maximum values of the existing directions and throttle, you also need to pick up the MT12 and move it back and forth and side to side, with angles greater than 45 degrees. 3. Input menu settings. Press the “MDL” button, then use the “PAGE” button to navigate to the “INPUT” menu. You must bind the gyro output to two input channels in this menu. For example, bind Axis X (S3) to “I09”
