racedayquadsRUNCAM· Commande de moteurs
SpeedyBee V3 F722 3-6S 30x30 Stack/Combo (F722 FC / 50A 32bit 4in1 ESC)
Réf. fabricant 19196
180.27 $≈ 156.23 €
Réf. fabricant 19196
Vendu par racedayquads à 156.23 €. Livré en France, port, TVA et droits de douane éventuels compris, il revient à environ 205.48 €. Prix relevés le 2026-09-16.
Le coût livré est une estimation pour un article seul expédié en France métropolitaine ; seul le panier du vendeur fait foi.
| Article | 156.23 € |
|---|---|
| Frais de port | 15.00 € |
| TVA (20 %) | 34.25 € |
| Total livré | 205.48 € |
Estimation pour un article seul livré en France métropolitaine, expédié hors UE : des droits de douane et frais de dédouanement peuvent s'ajouter, facturés par le transporteur.
| Courant | 50 A |
| Poids | 104 g |
The SpeedyBee V3 F722 3-6S 30x30 Stack/Combo (F722 FC / 50A 32bit 4in1 ESC) is a marvel to behold. The latest iteration of the SpeedyBee Stack, the V3 is packed with powerful new upgrades. Faster Wi-Fi upgrades, black box retrieval within a minute, supports up to 8 motors, and features soldering pads on one end, and pin connectors on the other in case soldering isn't your thing. The 50A 4in1 ESC is fitted with a high-quality CNC heat sink shield to significantly reduce the heat from your MOSFETs ensuring stable current flow at a high-throttle position. This ESC should have no issues with overheating. A great benefit in a stylish blue finish. Check out our other 30x30 Stacks and all our Speedy Bee products! Specifications F722 2-6S Flight Controller MCU: STM32F722 IMU: BMI270 USB: Type-C Baro: BMP280 (I2C) OSD: BetaFlight OSD w/ AT7456E chip BLE Support, used for Flight Controller configuration WiFi Support, used for data transfer, e.g firmware flashing, and Blackbox analysis. DJI Air Unit plug: A full DJI Air Unit JST slot onboard BlackBox: 500MB onboard data flash BetaFlight Camera Control Pad: Yes Power input: 3S - 6S Lipo 10 groups of 5V output, three +5V pads and 1 BZ+ pad (used for Buzzer) on front side, and 6 +5V output included in the connectors on bottom side. The total current load is 2A. 2 groups of 9V output, one +9V pad on front side and other included in a connector on bottom side. The total current load is 4A. Supported. Designed for receiver and GPS module even when the FC is powered through the USB port. Up to 1A current load. Supported. Designed for 3.3V-input receivers. Up to 500mA current load. ESC signal M1 - M4 on bottom side and M5-M8 on front side. UART: 5 sets (UART1, UART2, UART3, UART4, UART6) ESC Telemetry: UART UART4 RX I2C: Supported. SDA & SCL pads on front side. Used for magnetometer, sonar, etc. LED: Used for WS2812 LED controlled by Betaflight firmware. Buzzer: BZ+ and BZ- pad used for 5V Buzzer Boot button: Yes RSSI input: Yes Smart
