racedayquadsAIRBOT
Airbot OpenLager MicroSD Blackbox Module
Réf. fabricant AIRB-OpenLager
30.93 $≈ 26.80 €
Le prix en résumé
Vendu par racedayquads à 26.80 €. Livré en France, port, TVA et droits de douane éventuels compris, il revient à environ 50.16 €. Prix relevés le 2026-09-16.
Le coût livré est une estimation pour un article seul expédié en France métropolitaine ; seul le panier du vendeur fait foi.
En stock
Coût total livré estimé
| Article | 26.80 € |
|---|---|
| Frais de port | 15.00 € |
| TVA (20 %) | 8.36 € |
| Total livré | 50.16 € |
Estimation pour un article seul livré en France métropolitaine, expédié hors UE : des droits de douane et frais de dédouanement peuvent s'ajouter, facturés par le transporteur.
Description
The Airbot OpenLager gives the capability of black box recording to any drone that doesn't have it. This is fantastic for tuning and finding issues in your system. This device needs to be flashed with updated firmware before use. Follow the simple instructions in the wiring & info tab. Check out our other flight controller accessories, as well as the rest of our Airbot selection! Features It's faster than an average black box with a 4 bit SD interface clocked at 19.2MHz with DMA. It has buffer memory to ride out times when the SD card is busy (125kbytes with the current firmware) It fits in a smaller form factor builds with ease. ESD protection on input pins. And it has a flip-up microSD connector that is better at retaining the card in crashes and hard landings. Specifications Dimensions: 20x15mm Weight: 2g Includes 1x Airbot OpenLager Blackbox Wiring & Info The OpenLager is easy to use with async serial. First, wire according to the diagram below (an example of an OpenPilot-style connector is in the drawing). Note that you should attach the flight board's TX to Openlager's RX pin! OpenLager has an onboard regulator and can be powered with 3.3-5.5V (the regulator dropout voltage is low enough that the SD card will still work properly at 3.3V input). SD CARD MUST BE FAT16 OR FAT32 FORMAT. FIRMWARE MUST BE UPDATED BEFORE USING: Format your SD card. It must be either FAT or FAT32 format (SanDisk Extreme Pro 8GB recommended) Put the firmware lager.bin file into the sdcard and insert into the OpenLager Power on. The RED led should blink for several seconds. Wait until the RED led is stops blinking and continue to wait 10s more. Power off Format the SD card again Insert the SD card into OpenLager and power on. Power off; remove the card, and attach it to your computer. You'll find openLager has written a file to it called lager.cfg: { "startupMorse" : "", "useSPI" : false, "baudRate" : 2000000, "preallocBytes" : 104857600, "preallocGrow" : false} The important field to c
