racedayquadsMATEK
Matek AP_Periph CAN-L4-BM Digital Power Monitor
Réf. fabricant MATE-CAN-L4-BM
42.83 $≈ 37.12 €
Le prix en résumé
Vendu par racedayquads à 37.12 €. Livré en France, port, TVA et droits de douane éventuels compris, il revient à environ 62.54 €. Prix relevés le 2026-09-16.
Le coût livré est une estimation pour un article seul expédié en France métropolitaine ; seul le panier du vendeur fait foi.
En stock
Coût total livré estimé
| Article | 37.12 € |
|---|---|
| Frais de port | 15.00 € |
| TVA (20 %) | 10.42 € |
| Total livré | 62.54 € |
Estimation pour un article seul livré en France métropolitaine, expédié hors UE : des droits de douane et frais de dédouanement peuvent s'ajouter, facturés par le transporteur.
Historique de prix
2 relevés de prix/stock depuis le 20/08/2026
Caractéristiques (extraites automatiquement)
Mécanique
| Poids | 9 g |
Description
The Matek AP_Periph CAN-L4-BM CAN Digital Power Monitor offers ultra-precise monitoring for your drone needs. It features a low-power resistant path of 200μΩ, providing high efficiency in power consumption. No calibration is required and DroneCAN protocol offers convenient current & bus voltage readouts. Enjoy precision monitoring and convenience with the AP_Periph CAN CAN-L4-BM. Check out all our GPS modules, and our full line of Matek products! Specifications MCU: STM32L431xC, 256KB Flash INA239 85-V, 16-Bit, High-Precision Power monitor IC With SPI Interface Battery Voltage sense input: 0~85V Current Sense Range: 0~204.8A Load current on current sensing resistor: 150A(Continuous), 204.8A(Burst) Voltage accuracy: ± 0.1% Current accuracy: ± 2% Interface: CAN, DroneCAN Protocol, U-ART2, spare, DFU, -ST debug, SWCLK & SWDIO LED: Blue, (Fast blinking, Booting), Blue, (Slow blinking, working) Red, (3.3V indicator) Power supply for CAN-L4-BM board: 4.5~5.5V @5V pad/pin Power consumption: 10mA Operating Temperatures: -40~85 °C Board Size: 30mm x 22mm x 3mm. Weight: 4g 3D file: CAN-L4-BM_STEP.zip Firmware: ArduPilot AP_Periph MatekL431-BattMon Update: via DroneCAN GUI Tool Parameters: CAN_P1_DRIVER = 1 if attached to CAN bus1 port or CAN_P2_DRIVER = 1 if attached to CAN bus2 port, BATTx_MONITOR = 8 (DroneCAN-BatteryInfo) Tips The big pad on the bottom side is a dead pad. No any circuit network on it. Solder the positive wires as close as possible to both sides of the current sensing resistor. 2 ears for mounting can be cut off if you don’t need it. If the CAN wires are too long, bridge the “120R” jumper. Includes 1x Matek AP_Periph CAN-L4-BM Digital Power Monitor 1x JST-GH-4P to JST-GH-4P 20cm silicon wire Wiring Diagram
