racedayquadsMATEK
Matek AP_Periph CAN-L4-BM Digital Power Monitor
Manufacturer part no. MATE-CAN-L4-BM
$42.83≈ 37.12 €
Price summary
Listed by racedayquads at €37.12. Delivered to France, including shipping, VAT and any customs duty, it comes to about €62.54. Prices last checked on 2026-09-16.
Delivered cost is an estimate for a single item shipped to mainland France; the seller's checkout is authoritative.
In stock
Estimated landed cost
| Item | €37.12 |
|---|---|
| Shipping | €15.00 |
| VAT (20%) | €10.42 |
| Total delivered | €62.54 |
Estimate for a single item delivered to mainland France, shipped from outside the EU: customs duty and clearance fees may apply and are charged by the carrier.
Price history
2 price/stock records since 8/20/2026
Specifications (automatically extracted)
Mechanical
| Weight | 9 g |
Description
The Matek AP_Periph CAN-L4-BM CAN Digital Power Monitor offers ultra-precise monitoring for your drone needs. It features a low-power resistant path of 200μΩ, providing high efficiency in power consumption. No calibration is required and DroneCAN protocol offers convenient current & bus voltage readouts. Enjoy precision monitoring and convenience with the AP_Periph CAN CAN-L4-BM. Check out all our GPS modules, and our full line of Matek products! Specifications MCU: STM32L431xC, 256KB Flash INA239 85-V, 16-Bit, High-Precision Power monitor IC With SPI Interface Battery Voltage sense input: 0~85V Current Sense Range: 0~204.8A Load current on current sensing resistor: 150A(Continuous), 204.8A(Burst) Voltage accuracy: ± 0.1% Current accuracy: ± 2% Interface: CAN, DroneCAN Protocol, U-ART2, spare, DFU, -ST debug, SWCLK & SWDIO LED: Blue, (Fast blinking, Booting), Blue, (Slow blinking, working) Red, (3.3V indicator) Power supply for CAN-L4-BM board: 4.5~5.5V @5V pad/pin Power consumption: 10mA Operating Temperatures: -40~85 °C Board Size: 30mm x 22mm x 3mm. Weight: 4g 3D file: CAN-L4-BM_STEP.zip Firmware: ArduPilot AP_Periph MatekL431-BattMon Update: via DroneCAN GUI Tool Parameters: CAN_P1_DRIVER = 1 if attached to CAN bus1 port or CAN_P2_DRIVER = 1 if attached to CAN bus2 port, BATTx_MONITOR = 8 (DroneCAN-BatteryInfo) Tips The big pad on the bottom side is a dead pad. No any circuit network on it. Solder the positive wires as close as possible to both sides of the current sensing resistor. 2 ears for mounting can be cut off if you don’t need it. If the CAN wires are too long, bridge the “120R” jumper. Includes 1x Matek AP_Periph CAN-L4-BM Digital Power Monitor 1x JST-GH-4P to JST-GH-4P 20cm silicon wire Wiring Diagram
