racedayquadsHAPPYMODEL
HappyModel CrossF4 F411 1-2S 5A 8Bit AIO Whoop Flight Controller - ELRS 2.4GHz
Réf. fabricant 20544
64.25 $≈ 55.68 €
Le prix en résumé
Vendu par racedayquads à 55.68 €. Livré en France, port, TVA et droits de douane éventuels compris, il revient à environ 84.82 €. Prix relevés le 2026-09-16.
Le coût livré est une estimation pour un article seul expédié en France métropolitaine ; seul le panier du vendeur fait foi.
Disponibilité inconnue
Coût total livré estimé
| Article | 55.68 € |
|---|---|
| Frais de port | 15.00 € |
| TVA (20 %) | 14.14 € |
| Total livré | 84.82 € |
Estimation pour un article seul livré en France métropolitaine, expédié hors UE : des droits de douane et frais de dédouanement peuvent s'ajouter, facturés par le transporteur.
Caractéristiques (extraites automatiquement)
Électrique
| Courant | 5 A |
Mécanique
| Poids | 14 g |
Description
HappyModel continues to impress with yet another fantastic AIO for whoop applications! Check out the HappyModel CrossF4 1-2S AIO Whoop Flight Controller (F4 FC / 5A 4in1 ESC) - Featuring F411 Flight Controller, with a built in serial UART ELRS for V3.0. Browse the rest of our Whoop AIO Boards and all of our Happy Model products! Features BMI270 IMU (SPI connection) Serial UART ELRS V3.0 receiver Built-in 5V 1A BEC Specifications: AIO FC Firmware target: CRAZYBEEF4DX4.3.2 MCU:STM32F411CEU6 (100MHz, 512K FLASH) Sensor: BMI270(SPI connection) Power supply: 1-2S Lipo Lihv battery input (DC 2.8V~8.7V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot300 ready Built-in Betaflight OSD(SPI Control) Built-in UART ExpressLRS 2.4Ghz receiver(Default firmware ExpressLRS v3.0.1) Built-in 5V 1A BEC Built-in voltage detection and current sensor Built-in Onboard flash 16Mb for Blackbox Onboard 4in1 ESC MCU: EFM8BB21 Power supply: 1-2S LiPo/LiPo HV (2.8v~8.7v) Currents: 5A continuous peak 6A (5 seconds) Support BLHeliSuite programmable Default Factory firmware: S_H_50_REV16_8.HEX Support ESC Protocol: DSHOT150/DSHOT300/DSHOT600 Onboard UART ExpressLRS 2.4GHz Receiver Packet Rate: 25Hz/50Hz/150Hz/250Hz/500Hz RF Frequency: 2.4GHz Antenna: enameled copper wire 31mm length Telemetry output Power: <12dBm Receiver protocol: CRSF Default firmware version: ExpressLRS V3.0.1 The same hardware with Happymodel EP1 Could update firmware via ExpressLRS configurator Includes 1x HappyModel CrossF4 F411 1-2S 5A 8Bit AIO Whoop Flight Controller - ELRS 2.4gHz 1x Mounting Hardware 1x Wiring Harness Wiring Diagram & Betaflight Configuration NOTE: Onboard blackbox enable method:-Type the following command to CLI:-set blackbox_device = SPIFLASH-set flash_spi_bus = 2-resource FLASH_CS 1 a14 Pay attention: Bind procedure is the same like Happymodel EP1/EP2 receiver, as you need to upgrade your ExpressLRS TX module to V3.X version first. Alternative-Binding-Method-for-UART-Based-ELRS-RX
Produits similaires
racedayquadsEn stock
HappyModel Crazybee F4 Lite 1S Whoop Flight Controller for Mobula6 - Choose Your RX
80.43 €92.81 $
Voir chez le vendeur ↗
racedayquadsEn stock
HappyModel 1S F4 AIO Toothpick/Whoop Flight Controller w/ 5A 8bit 4in1 ESC & 200mW VTX - ELRS 2.4GHz SPI
86.62 €99.95 $
Voir chez le vendeur ↗
racedayquadsEn stock
EMAX Tinyhawk 3 1-2S F4 AIO Flight Controller 5A ESC 25/100/200mW VTX
111.37 €128.51 $
Voir chez le vendeur ↗
racedayquadsEn stock
iFlight Blitz F411 1S 5A Toothpick/Whoop Flight Controller w/ 25-50mW VTX & ELRS RX
86.62 €99.95 $
Voir chez le vendeur ↗
