Cardan joint KE outer diameter 25mm no bore material steel total length 74mm

MÄDLERMÄDLER

Cardan joint KE outer diameter 25mm no bore material steel total length 74mm

Name: Cardan joint KE outer diameter 25mm no bore material steel total length 74mm
Brand: MÄDLER
Price: 54.81 USD
Availability: InStock

Réf. fabricant 63002500

54.81 $≈ 47.52 €

Le prix en résumé

Vendu par MÄDLER à 47.52 €. Livré en France, port, TVA et droits de douane éventuels compris, il revient à environ 75.02 €. Prix relevés le 2026-08-05.

Le coût livré est une estimation pour un article seul expédié en France métropolitaine ; seul le panier du vendeur fait foi.

En stock — 5 unitésdélai 14 j

Voir chez le vendeur ↗

Coût total livré estimé

Détail du coût total livré
Article	47.52 €
Frais de port	15.00 €
TVA (20 %)	12.50 €
Total livré	75.02 €

Estimation pour un article seul livré en France métropolitaine, expédié hors UE : des droits de douane et frais de dédouanement peuvent s'ajouter, facturés par le transporteur.

Documentation technique

Caractéristiques (extraites automatiquement)

Mécanique

Poids

230 g

Autres caractéristiques

Length of bolt	26.5 mm
Length of bore	22 mm
Max torque	30 Nm
Outer diameter	25 mm
Total length	74 mm
Bore diameter	Without bore mm
Material	Steel (12L13)
Surface	Blank
Version	A

Description

Material: Steel 11SMn30 (1.0715). Max. Operating Angle 45°. The cardan joints KE are, other than the cardan joints with needle-roller bearing, only sliding-contact bearings. Their scope of application is therefore limited to slow running drives. The respective maximum speeds depend on operating angle and load, but must never exceed 1000 rpm. The maximum torque values listed in the table are limits, which must neither be exceeded. They may only be used to their full extend with intermittent operation or at low speed. The following limit applies: The product of speed (rpm) x working angle (degrees) may not exceed the reference number 500. This means, e.g., for a working angle of 10 degrees a max. speed of 50 rpm. If, however, the maximum torque is not taken to the limit, speed and working angle can be larger. At 0.5 x max. torque applies: speed x working angle, smaller or equal 4.000. In case of doubt choose larger joint. At continuous operation the cardan joints need to be sufficiently lubricated. If no drip-feed lubrication is possible, lubricate the joints at least once a day. Another possibility is to cover the joints with a bellow, filled with a suitable lubricant. Typ A: without bores. Type B: with bores. Type N: with bores and keyways DIN 6885-1 on both sides.