Manufacturer part no. 20165
Listed by holybro at €136.57. Delivered to France, including shipping, VAT and any customs duty, it comes to about €181.88. Prices last checked on 2026-09-16.
Delivered cost is an estimate for a single item shipped to mainland France; the seller's checkout is authoritative.
| Item | €136.57 |
|---|---|
| Shipping | €15.00 |
| VAT (20%) | €30.31 |
| Total delivered | €181.88 |
Estimate for a single item delivered to mainland France, shipped from outside the EU: customs duty and clearance fees may apply and are charged by the carrier.
| Weight | 120 g |
Updated: New Rev1.7 Recommending method: https://gui.fettec.net/FC/index.html Description: The Holybro FETtec FC G4 features the latest STM32 G4 MCU with math accelerator for the ultimate in-flight performance, onboard OSD for KISS flight tuning, 2 dedicated BECs for 5V and 16V switchable power, DSHOT2400 outputs for support of up to 8 motors, and dual 20x20 and 30x30 mounting holes. Note: Currently, the Holybro Fettec FC G4 does not support BLHeli_32 ESC Configuration via FC Passthrough and BLHeli_32 ESC telemetry/current reading. An Betaflight Flight Controller is needed to configure BLHeli32 ESC Setting. Specifications: Latest STM32G4 Processor 180Mhz + Math accelerator Gyro IIM-42652 SPI Supply voltage 6-27V (2S-6S Lipo) 2x dedicated onboard BEC (2A each) 5V BEC for RX 5V/16V BEC for VTX (switchable and real Pit*) Improved IO protection All IOs of the microcontroller e.g. in connectors or solder pads are protected against voltage or current spikes 2x 8 pin connector for solder free ESC connection Connector 1: ESC signal 1-4, telemetry, VCC, GND Connector 2: ESC signal 5-8 (depending on UAV type 1-4), telemetry, VCC, GND 1x 8 pin connector for solder free VTX, cam connection and OSD or digital systems real Pit* VCC, GND, Video in, Video out, BEC 5V/16V, VCS/TX3, RX3 2x 6 pin connectors for serials RX1, TX1, 3.3V, VCC, 5V, GND RX3, VCS/TX3, RGB LED, VCC, 5V, GND 1x 4 pin connector for receiver Signal, TLM, 5V, GND 5 UART serials UART 1 free UART 2 used for Receiver UART 3 free UART 4 free UART 5 used for ESCs / TLM / Onewire 4 ESC solder pads (Signal/GND) in each corner Buzzer pads 4 tiny RGB LEDs (selectable color) Supported ESC protocols PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire FETtec Alpha FC firmware (KISS FC firmware flashable) Connector type: JST-SH-1mm *real Pit-Mode: A power supply pin which is remotely switchable PINMAP Tekko32 F4 4in1 50A ESC F4 MCU @150Mhz / PWM output up to 96K / 4~6S / BLHeli32 / 30x30 The all new Tekko32
