Manufacturer part no. MATE-SAM-M10Q
Listed by racedayquads at €42.27. Delivered to France, including shipping, VAT and any customs duty, it comes to about €68.72. Prices last checked on 2026-09-16.
Delivered cost is an estimate for a single item shipped to mainland France; the seller's checkout is authoritative.
| Item | €42.27 |
|---|---|
| Shipping | €15.00 |
| VAT (20%) | €11.45 |
| Total delivered | €68.72 |
Estimate for a single item delivered to mainland France, shipped from outside the EU: customs duty and clearance fees may apply and are charged by the carrier.
| Weight | 14 g |
The Matek SAM-M10Q-5883 GNSS is a cutting-edge multi-constellation GNSS module featuring the advanced u-blox SAM-M10Q platform. It offers exceptional sensitivity and acquisition time for all L1 GNSS signals and can receive concurrent signals from four GNSS, including GPS, GLONASS, Galileo, and BeiDou. Its advanced Super-S technology further enhances RF sensitivity and dynamic position accuracy, even in challenging urban environments. Finally, with the high-gain 15 x 15 mm2 patch antenna provides the best balance between performance and small size. The omnidirectional antenna radiation pattern increases flexibility for device installation. Enjoy reliable readings for your drone navigation! Check out all our GPS modules, and our full line of Matek products! Features Simple design-in with no RF expertise required Less than 38 mW power consumption without compromising GNSS performance Maximum position availability with 4 concurrent GNSS reception Advanced spoofing and jamming detection Pin-compatible with previous SAM-M8Q Specifications GNSS u-blox SAM-M10Q-00B (GPS, GLONASS, Galileo and BeiDou) No Magnetic Compass built-in Patch antenna 15 x 15 x 4mm Input voltage range: 4~9V (5V pad/pin) Power consumption: 10mA UART baudrate: 9600 default Operating Temperatures: -20~80 °C UART(TX, RX) interface for GNSS SAM-M10Q-00B JST-GH-4P connector (SM04B-GHS-TB). 1.27mm pitch GNSS PPS LED, Green. (Solid ON after powering on, blinking(1Hz) when GNSS get 3D fix) Protocol: UBX(u-blox) 5Hz@GPS+GAL+BDS B1C+GLO or NMEA 1Hz 26mm x 16mm x 8mm 7.5g SAM-M10Q_step.zip Wiring and Settings AM-M10Q 5V to Flight controller 4~9V SAM-M10Q RX to Flight controller UART_TX SAM-M10Q TX to Flight controller UART_RX SAM-M10Q G to Flight controller GND Tips INAV 5.0.0, Betaflight 4.3.0, ArduPilot 4.3 or newer is required. UBlox NEO-M9N, MAX-M10S, SAM-M10Q series all don’t have dataflash built in. once GNSS is powered off and the supercapacitor run out. the settings will back to default. UBX protocol is
