adaptor for taper bush 1008 outside diameter 45mm material cast iron vs Bolt 3/4″ x 2″” for Taper bush 4545
adaptor for taper bush 1008 outside diameter 45mm material cast iron and Bolt 3/4″ x 2″” for Taper bush 4545 are compared below on the data published by their sellers — price converted to euros, stock, and every specification either seller discloses. On price, Bolt 3/4″ x 2″” for Taper bush 4545 is €3.81 cheaper ($9.53).
| Criterion |  adaptor for taper bush 1008 outside diameter 45mm material cast iron |  Bolt 3/4″ x 2″” for Taper bush 4545 |
|---|---|---|
| Price | $13.92 | $9.53cheapest |
| Seller | MÄDLER | MÄDLER |
| Availability | In stock | In stock |
| Rating | — | — |
| Weight | 100 g | 147 g |
| Depth of keyway adaptor | 2.5 mm | — |
| Depth of keyway hub | 2.8 mm | — |
| For clamp bushing | 1 008 | — |
| Key cross section | 5 x 5 mm | — |
| Length | — | 50.8 mm |
| Material | Grey cast iron (A48) | Steel |
| Min hub diameter for cast iron | 75 mm | — |
| Min hub diameter for steel | 60 mm | — |
| Outer diameter | 45 mm | 19.05 mm |
| Size inch | — | BSW 3/4 x 2 |
| Suitable for clamping bushing type from | — | 4 545 |
| Surface | Blank | Blank |
| Thread pitch | — | 2.54 mm |
| Tightening torque | — | 190 Nm |
| Tolerance length | — | +/-1.0 mm |
| Tolerance outer diameter | — | -0.25 mm |
| Tolerance thread pitch | — | +/-0.25 mm |
| Tolerance wrench size | — | 0.27 mm |
| Total length | 22 mm | — |
| Wrench size | — | 14 mm |
| View at seller ↗ | View at seller ↗ |
Specifications are extracted automatically from seller data — an empty cell means the seller does not publish that value, not that the product lacks it.
Robotitem does not test products. This comparison reports seller-published data only, and ranking never takes affiliate commission into account.