adaptor for taper bush 1615 outside diameter 70mm material cast iron vs Bolt 7/8″ x 2 1/4″” for Taper bush 5050
adaptor for taper bush 1615 outside diameter 70mm material cast iron and Bolt 7/8″ x 2 1/4″” for Taper bush 5050 are compared below on the data published by their sellers — price converted to euros, stock, and every specification either seller discloses. On price, Bolt 7/8″ x 2 1/4″” for Taper bush 5050 is €8.78 cheaper ($15.61).
| Criterion |  adaptor for taper bush 1615 outside diameter 70mm material cast iron |  Bolt 7/8″ x 2 1/4″” for Taper bush 5050 |
|---|---|---|
| Price | $25.73 | $15.61cheapest |
| Seller | MÄDLER | MÄDLER |
| Availability | In stock | In stock |
| Rating | — | — |
| Weight | 380 g | 227 g |
| Depth of keyway adaptor | 4 mm | — |
| Depth of keyway hub | 4.3 mm | — |
| For clamp bushing | 1 615 | — |
| Key cross section | 10 x 8 mm | — |
| Length | — | 57.15 mm |
| Material | Grey cast iron (A48) | Steel |
| Min hub diameter for cast iron | 115 mm | — |
| Min hub diameter for steel | 95 mm | — |
| Outer diameter | 70 mm | 22.23 mm |
| Size inch | — | BSW 7/8 x 2 1/4 |
| Suitable for clamping bushing type from | — | 5 050 |
| Surface | Blank | Blank |
| Thread pitch | — | 2.822 mm |
| Tightening torque | — | 270 Nm |
| Tolerance length | — | +/-1.0 mm |
| Tolerance outer diameter | — | -0.25 mm |
| Tolerance thread pitch | — | +/-0.25 mm |
| Tolerance wrench size | — | 0.27 mm |
| Total length | 38 mm | — |
| Wrench size | — | 14 mm |
| View at seller ↗ | View at seller ↗ |
Specifications are extracted automatically from seller data — an empty cell means the seller does not publish that value, not that the product lacks it.
Robotitem does not test products. This comparison reports seller-published data only, and ranking never takes affiliate commission into account.