holybroHolybro
Durandal
Réf. fabricant 11039+15010
233.98 $≈ 203.80 €
Le prix en résumé
Vendu par holybro à 203.80 €. Livré en France, port, TVA et droits de douane éventuels compris, il revient à environ 262.56 €. Prix relevés le 2026-09-18.
Le coût livré est une estimation pour un article seul expédié en France métropolitaine ; seul le panier du vendeur fait foi.
Disponibilité inconnue
Coût total livré estimé
| Article | 203.80 € |
|---|---|
| Frais de port | 15.00 € |
| TVA (20 %) | 43.76 € |
| Total livré | 262.56 € |
Estimation pour un article seul livré en France métropolitaine, expédié hors UE : des droits de douane et frais de dédouanement peuvent s'ajouter, facturés par le transporteur.
Caractéristiques (extraites automatiquement)
Mécanique
| Poids | 280 g |
Description
Overview Durandal is a flight controller designed by Holybro utilizing the STM32H7 microcontroller series. It comes with built-in vibration isolation system and integrated IMU heater for sensors temperature control. Key Design Points: High performance H7 Processor with clock speed up to 480 MHz Redundant inertial measurement unit (IMU) from Bosch® & InvenSense® Built-in Vibration isolation system to filter out high frequency vibration and reduce noise to ensure accurate readings IMUs are temperature-controlled by onboard heating resistors, allowing optimum working temperature of IMUs 2 power ports & 5 general purpose serial ports Two Power ports for redundancy Technical Specifications Processors & Sensors Main FMU Processor: STM32H743 32 Bit Arm ® Cortex®-M7, 480MHz, 2MB memory, 1MB RAM IO Processor: STM32F100/F103 32 Bit Arm ® Cortex® On-board sensors Accel/Gyro: ICM-20689 Accel/Gyro: ICM-20602 / BMI088 Mag: IST8310 Barometer: MS5611 Electrical Data Voltage Ratings: Max input voltage: 6V USB Power Input: 4.75~5.25V Servo Rail Input: 0~36V Current Ratings: Telem1 Max output current limiter: 1.5A All other port combined output current limiter: 1.5A Mechanical Data: Dimensions:80*45*20.5mm Weight: 68.8g Interfaces 13 PWM outputs (8 from IO, 5 from FMU) 5 general purpose serial ports 3 with full flow control 1 with separate 1.5A current limit (Telem1) 3 I2C ports 4 SPI buses 1 internal high speed SPI sensor bus with 4 chip selects and 6 DRDYs 1 internal low noise SPI bus dedicated for XXX Barometer with 2 chip selects, no DRDYs 1 internal SPI bus dedicated for FRAM Supports temperature control located on sensor module 1 external SPI buses Up to 2 CANBuses for dual CAN Each CANBus has individual silent controls or ESC RX-MUX control Analog inputs for voltage / current of 2 batteries 6 dedicated PWM/Capture inputs on FMU Dedicated R/C input for Spektrum / DSM Dedicated R/C input for CPPM and S.Bus Dedicated S.Bus servo output and analog / PWM RSSI input 2 additional anal
