racedayquadsDarwinFPV

DarwinFPV HULK F411/45A 3-6S AIO Flight Controller w/ SPI ELRS 2.4GHz

Name: DarwinFPV HULK F411/45A 3-6S AIO Flight Controller w/ SPI ELRS 2.4GHz
Brand: DarwinFPV
Price: 185.63 USD

Réf. fabricant 21285

185.63 $≈ 160.87 €

Le prix en résumé

Vendu par racedayquads à 160.87 €. Livré en France, port, TVA et droits de douane éventuels compris, il revient à environ 211.04 €. Prix relevés le 2026-09-16.

Le coût livré est une estimation pour un article seul expédié en France métropolitaine ; seul le panier du vendeur fait foi.

Disponibilité inconnue

Voir chez le vendeur ↗

Coût total livré estimé

Détail du coût total livré
Article	160.87 €
Frais de port	15.00 €
TVA (20 %)	35.17 €
Total livré	211.04 €

Estimation pour un article seul livré en France métropolitaine, expédié hors UE : des droits de douane et frais de dédouanement peuvent s'ajouter, facturés par le transporteur.

Caractéristiques (extraites automatiquement)

Électrique

Courant

45 A

Mécanique

Poids

73 g

Description

This AIO has a rating of IP67, In ideal conditions submersion of 1 meter for 30 minutes can be achieved. Introducing the all-new DarwinFPV Hulk AIO! Having IP67 water-resistant grading, 45A BLS ESC, and Onboard ELRS SPI receiver. This AIO is ready for any adventure that you can and couldn't take your drone!!! Check out our other AIO Flight Controllers and our Darwin FPV products! Specifications AIO F411 MCU: STM32F411CEU6 Gyro: MPU6500 OSD Chip: Betaflight OSD AT7456E Blackbox: 16MB UARTS: 5 I2C: SDA / SLA pads LED: Yes Beeper: Yes Firmware Target: MATEKF405 FC Mounting Pattern: 30x30mm Dimensions: 37x36x10.8mm AIO ESC Input Voltage: 2-6S Max. Continuous Current: 45A Max. Burst Current: 55A MCU: EFM8BB21F16G Current Sensor: Yes Mounting Dimensions: 25 x 25 M2 Dimensions 46.2mm x 39.5mm x 10mm Includes 1x Darwin FPV HULK F411/45A 3-6S AIO w/ ELRS 2.4GHz Please attention: Seawater is highly corrosive, it is not recommended for use in seawater. Please wash it with fresh water immediately and then dry it. Supports a 3-6S battery, remember not to plug the battery's positive and negative interface in reverse, otherwise, it will burn out. After receiving the AIO, first connect to a computer on Betaflight software to check whether the gyroscope and accelerometer are detected and whether the gyroscope attitude is normal. Increase the throttle in Betaflight software to ensure the normal rotation and correct rotation direction of the 4 motors, and then install the propellers for a test flight; be sure to remove the propellers when pulling the throttle in Betaflight software to avoid accidents. After confirming the above precautions without any problems, you can install the propellers and start flying! Wiring Diagram