betafpvBetaFPV
F3 EVO Brushed Flight Controller (Frsky Rx)
Manufacturer part no. 17022435
$19.99$29.99−33 %≈ 17.32 €
Price summary
Listed by betafpv at €17.32. Delivered to France, including shipping, VAT and any customs duty, it comes to about €38.78. Prices last checked on 2026-09-16.
Delivered cost is an estimate for a single item shipped to mainland France; the seller's checkout is authoritative.
Availability unknown
Estimated landed cost
| Item | €17.32 |
|---|---|
| Shipping | €15.00 |
| VAT (20%) | €6.46 |
| Total delivered | €38.78 |
Estimate for a single item delivered to mainland France, shipped from outside the EU: customs duty and clearance fees may apply and are charged by the carrier.
Specifications (automatically extracted)
Mechanical
| Weight | 20 g |
Description
Since the born of the BETAFPV brushed F3 EVO flight controller, many whoop pilots give us their advice and ideas. The rear mounting point is concerned mostly. I do not like the design of the fc. The usb port is in a place where it can not be used. I don't like that there is no rear mounting point because the usb port is in it's place. -------- by Chris Reese The "high brightness LEDs" are awesome. It fits an inductrix frame perfectly. I thought I was going to have to shave off a hair from the back screw post, but it turns out, I didn't need to "mod" the frame in any way for this FC to fit. Would/will highly recommend. --------- by Ilikecmyk This does not fit the stock inductrix frames. There is no rear hole for the grommet and screw on the board. It would require cutting the rear mounting post on the frame for the board to lay flat. My concern is, even if you cut the peg, you're losing one mounting point, allowing the frame to flex and or cause vibrations. ----------- by Trike Thanks to all the guys send message to us. Newest V1.1 version is designed to fit with stock Whoop Quadcopter or Blade Inductrix frames completely. Add the rear mounting point for the grommet and screw on the board. Key Features Fully programmable through Betaflight, using the onboard USB port, tune all the parameters, PID's, and rates to your perfect settings Designed to work with current Whoop Quadcopter or Blade Inductrix setups Built in Frsky D8 protocol native receiver, compatible with almost ALL Frsky radios(e.g. Taranis X9D/X9D Plus/X7) or Frsky compatible transmitter module With PA integrated, up to 0.5 Kilometers long range, with RSSI telemetry The flight controller board comes pre-flashed with Betaflight firmware, and pre-soldered 55mm power cable pigtail with JST-PH 2.0 connector, AKA PowerWhoop connector. Here is the comparison chat of several popular Whoop flight controller. Specifications CPU: STM32F303CCT6 Six-Axis: MPU6500 Size: 26mm x 26mm,fully compatible with the Inductrix q
