Manufacturer part no. 23735
Listed by racedayquads at €79.40. Delivered to France, including shipping, VAT and any customs duty, it comes to about €113.28. Prices last checked on 2026-09-16.
Delivered cost is an estimate for a single item shipped to mainland France; the seller's checkout is authoritative.
| Item | €79.40 |
|---|---|
| Shipping | €15.00 |
| VAT (20%) | €18.88 |
| Total delivered | €113.28 |
Estimate for a single item delivered to mainland France, shipped from outside the EU: customs duty and clearance fees may apply and are charged by the carrier.
| Current | 50 A |
| Weight | 64 g |
The TBS Lucid Wing AIO - H7 FC + 50A 2-6S AM32 ESC is your quick plug & play wing FC for big wings! Flying wings up to 1m wingspan, or approximately 1.5kg of takeoff weight. Running the STM32H7 chip, a custom AM32 50A ESC in a sleek, heat-dissipating plastic case with plug connectors for peripherals such as servos, VTX, Camera, GPS and external USB. Designed for both seasoned pros and enthusiastic newcomers, this flight controller takes the chore out of building your FPV setup and gets you up and running quicker and easier. Browse the rest of our Wing Gear as well as our TBS Products! Features All-in-One Wing Solution Plug & Play Connectors Powerful H743 Processor Dual Gyro System. 50A AM32 ESC Specifications MCU: STM32H743VIH6 running at 480MHz, with 1MB RAM and 2MB Flash Gyro: ICM42688 x 2 (duo gyro) OSD Chip: AT7456E (SPI2) Barometer: Infineon DPS310 connected via I2C2 PWM Outputs: 6 channels external, 1 internal for ESC Blackbox (BB): Data logging equipped with a MicroSD card slot (SDIO) UARTs: 5 ext, 2 int] UART1(RX only)/UART2/UART3/UART4/UART6/UART7(RX only, internal ESC)/UART8 (internal pads) I2C Buses: 2 (1x GPS, 1x barometer - internal) CAN Bus: 1x Analog Inputs: 2 ADC internal channels (VBAT, Current). LED Indicators: 3 LEDs (not visible) USB Interface: Type-C connector (USB 2.0 standard) JST Connectors: 1x JST-SH1.0 4-pin (Receiver) 3x JST-SH1.0 6-pin (USB extender, GPS, VTX) 1x JST-GH1.25 4-pin (CAN bus) Power Control: Switch for filtered 5V/6.2V/7V/8.4V servo output power DJI FPV OSD: Compatible via spare UART port Power Specifications Input Voltage: 6 - 26V (2 to 6S LiPo). BEC #1: 5V/6V/7.2V 5A (Servos, digital VTX, analog VTX, analog camera) BEC #2: 5V 1A (Receiver, GPS, CAN bus) Battery voltage sensor: 1K:20K (Scale 2100 in INAV, BATT_VOLT_MULT 21.0 in ArduPilot) Current sense ADC: 3.2V @ 160A Power Consumption: 200mA @ 5V with Betaflight, 150mA @ 5V with ArduPilot. Important Note: The DJI Switch will only output vbat. Contact TBS support for instru
