
Manufacturer part no. HAPP-5A10087
Listed by racedayquads at €142.31. Delivered to France, including shipping, VAT and any customs duty, it comes to about €188.77. Prices last checked on 2026-09-16.
Delivered cost is an estimate for a single item shipped to mainland France; the seller's checkout is authoritative.
| Item | €142.31 |
|---|---|
| Shipping | €15.00 |
| VAT (20%) | €31.46 |
| Total delivered | €188.77 |
Estimate for a single item delivered to mainland France, shipped from outside the EU: customs duty and clearance fees may apply and are charged by the carrier.
| Weight | 73 g |
The Happymodel Mobula6 2024 1S 65mm Ultra Light Micro FPV 1S Whoop comes equipped with a lightweight AIO flight controller and 2.4Ghz ELRS receiver. The drone is Ready to Rip! Check out our other pre-built quads, as well as the rest of our HappyModel selection! Features AIO Flight controller with Serial ELRS Receiver and 5.8G Openvtx Super light 1S 65mm Brushless whoop only 17.7g Equipment with the lightest brushless motors-SE0702 only 1.46gram FX17-B 1/3 CMOS 800TVL Camera awesome footage Smooth and powerful Compatible for 1S Lipo/LIHV Specifications Wheelbase: 65mm Size: 81mm x 81mm x 37mm Weight: 17.7g Option: -V1 version with SuperX ELRS V1.0 AIO -V2 version with SuperX ELRS V2.0 AIO The only difference is v2.0 AIO FC comes with motor plug but V1.0 AIO FC is no motor plug. Motors Mode: SE0702 KV28000 Configu-ration: 9N12P Stator Diamter: 7mm Stator Length: 2mm Shaft Diameter: Φ1mm Motor Dimension(Dia.xLen): Φ9.5mm x 14mm Weight(g): 1.46g No.of Cells(Lipo): 1S only Propellers Materials: PC Inch: 31mm Pitch: 0.8 in Weight: 0.21g Mount hole diameter: 1mm AIO SuperX ELRS AIO 5-IN-1 Flight controller MCU:STM32F411CEU6 (100MHZ, 512K FLASH) ,ESP32-PICO-D4 Sensor:BMI270(SPI connection) Mount hole size: 25.5mm x 25.5mm Power supply: 1S battery input (DC 2.9V-4.35V) Built-in 5A(each) Blheli_S 4in1 ESC Built-in Betaflight OSD(SPI Control) Built-in 5.8G OpenVTX 0mw~400mw (MSP control) Built-in UART ExpressLRS v3.0.0 Built-in voltage meter sensor , voltage meter scale 110 Built-in current meter sensor , current meter scale 1175 Power supply: 1S LiPo/LiPo HV Current: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: Bluejay v0.19.2 Default protocol: DSHOT300 Recommend ESC Startup power value to min1100/max1200 Onboard Serial ExpressLRS receiver Packet Rate option: 50Hz/150Hz/250Hz/500Hz ExpressLRS Firmware version: V3.0 RF Frequency: 2.4GHz Antenna : Enameled copper wire antenna Telemetry output Power: <12dBm Receiver protocol: Serial_based



