Manufacturer part no. 19251
Listed by racedayquads at €92.81. Delivered to France, including shipping, VAT and any customs duty, it comes to about €129.37. Prices last checked on 2026-09-16.
Delivered cost is an estimate for a single item shipped to mainland France; the seller's checkout is authoritative.
| Item | €92.81 |
|---|---|
| Shipping | €15.00 |
| VAT (20%) | €21.56 |
| Total delivered | €129.37 |
Estimate for a single item delivered to mainland France, shipped from outside the EU: customs duty and clearance fees may apply and are charged by the carrier.
| Weight | 32 g |
The Matek AP_Periph Drone CAN GNSS - M10-L4-3100 has a GPS, Compass, and Barometer! Ready for whatever your aircraft can throw at it! Check out our GPSs, BECs, PDBs, Sensors and all of our Matek Products! Features M10-L4-3100 is based on ArudPilots’ AP_Periph firmware, It is a GNSS+COMPASS+BAROMETER peripheral with CAN/DroneCAN and UART/MSP interfaces. M10-L4-3100 uses multi-constellation GNSS powered by u-blox M10 series , It is a concurrent GNSS receiver which can receive and track multiple GNSS systems. Owing to the multi-band RF front-end architecture all four major GNSS constellations, GPS,Galileo, GLONASS and BeiDou can be received concurrently. M10-L4-3100 integrates an industrial-grade compass PNI RM3100 which provides high resolution, low power consumption, no hysteresis, large dynamic range, and high sampling rates. Specifications ublox GNSS M10 series (GPS, GLONASS, Galileo and BeiDou) Magnetic Compass: RM3100 Barometer: SPL06-001 Patch GNSS Antenna: 25x25x4mm MCU STM32L431RCT6 UART3, onboard M10 GNSS module UART2(TX2 RX2), MSP Protocol CAN, DroneCAN Protocol I2C JST-GH connector for external AirSpeed sensor CAN bootloader LED, Blue Fast blinking, Booting Slow blinking, working GNSS PPS LED, Green solid on after powering on blinking(1Hz) when GNSS has 3D fixed 3.3V LED, Red Input voltage range: 4.5~5.3V (5V pad/pin) Power consumption: 60mA Operating Temperatures: -20~80 °C Dimensions: 36mm*36mm*12mm Weight:16g Firmware ArduPilot AP_Periph: MatekL431-GPS or MatekL431-Periph Tips & Notes on M10-F4-3100, The 3 magnetic coils have little solder paste to avoid the excess to “tilt” them, resulting in some reading inaccuracies of the compass. Any strong impacts will definitely separate them, especially the “tall coil” Sen-Z-f. Please use this precision module with care. The default configuration on MAX-M10S with ublox FW5.1 is concurrent reception of GPS, Galileo, and BeiDou B1I with QZSS and SBAS enabled. GLONASS is disabled by default. Beidou B1I (1561.098 MHz
