holybroHolybro
PM02D Power Module(2S-12S)
Réf. fabricant 15011
24.99 $≈ 21.66 €
Le prix en résumé
Vendu par holybro à 21.66 €. Livré en France, port, TVA et droits de douane éventuels compris, il revient à environ 43.99 €. Prix relevés le 2026-09-16.
Le coût livré est une estimation pour un article seul expédié en France métropolitaine ; seul le panier du vendeur fait foi.
En stock
Coût total livré estimé
| Article | 21.66 € |
|---|---|
| Frais de port | 15.00 € |
| TVA (20 %) | 7.33 € |
| Total livré | 43.99 € |
Estimation pour un article seul livré en France métropolitaine, expédié hors UE : des droits de douane et frais de dédouanement peuvent s'ajouter, facturés par le transporteur.
Caractéristiques (extraites automatiquement)
Mécanique
| Poids | 50 g |
Description
Note PM02D HV version is supported by PX4. For Ardupilot, it is supported in version 4.4 and later. Full setup guide can be found here. This PM uses I2C digital signal data output, Compatible with Pixhawk 5X/6X Series. NOT compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers. Power Module Comparison Table Description PM02D provides regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 12S (HV). The Power Module comes completely assembled with XT60 connectors, wrapped in shrink tubing for physical damage protection.It is not designed to power servos, please use your aircraft's ESC/BEC for that. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact. Specification Input voltage : 2S-12S PCB Cont. Current Rating: 60A PCB Burst Current Rating: 100A (<60 Sec) Max current sensing: 327A Voltage and current monitor with I2C compatible interface Outputs 5.2V and 3A max Weight: 20g Current Rating: The PM02D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. You can refer to this chart as reference. PIN MAP: Setup: If you are using the PM02D HV version, you must set SENS_EN_INA228 to enable. Full setup guide can be found here. Package Includes： 1x PM02D Power Module 1x 6pin 2.00mm pitch cable
