holybroHolybro
PM06D Power Module (14S)
Réf. fabricant 15020
33.59 $≈ 29.11 €
Le prix en résumé
Vendu par holybro à 29.11 €. Livré en France, port, TVA et droits de douane éventuels compris, il revient à environ 52.93 €. Prix relevés le 2026-09-16.
Le coût livré est une estimation pour un article seul expédié en France métropolitaine ; seul le panier du vendeur fait foi.
En stock
Coût total livré estimé
| Article | 29.11 € |
|---|---|
| Frais de port | 15.00 € |
| TVA (20 %) | 8.82 € |
| Total livré | 52.93 € |
Estimation pour un article seul livré en France métropolitaine, expédié hors UE : des droits de douane et frais de dédouanement peuvent s'ajouter, facturés par le transporteur.
Caractéristiques (extraites automatiquement)
Mécanique
| Poids | 50 g |
Description
Note - PM06D is supported by PX4. For Ardupilot, it is supported in version 4.4 and later. - This PM uses I2C digital signal data output and is not compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers. PM06D provides a regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6-pin cable. It has built-in power distribution, allowing you to power your ESC and FC with the same board. The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with an XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact. Specification Input voltage: 2S- 14S PCB Cont. Current Rating: 70A PCB Burst Current Rating: 120A (<60 Sec) Max current sensing: 327A Voltage and current monitor with I2C compatible interface Connector Outputs: 5.2V and 3A max Weight: 24.5g Current Rating: The PM06D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. You can refer to this chart as a reference. PX4 Parameter Setup: If you are using the PM06D 14S version, you must set SENS_EN_INA228 to enable it. Pinout Package Includes： 1x PM06D Power Module 1x 6-pin 2.00mm pitch cable
