holybroHolybro
PM06D Power Module (14S)
Manufacturer part no. 15020
$33.59≈ 29.11 €
Price summary
Listed by holybro at €29.11. Delivered to France, including shipping, VAT and any customs duty, it comes to about €52.93. Prices last checked on 2026-09-16.
Delivered cost is an estimate for a single item shipped to mainland France; the seller's checkout is authoritative.
In stock
Estimated landed cost
| Item | €29.11 |
|---|---|
| Shipping | €15.00 |
| VAT (20%) | €8.82 |
| Total delivered | €52.93 |
Estimate for a single item delivered to mainland France, shipped from outside the EU: customs duty and clearance fees may apply and are charged by the carrier.
Specifications (automatically extracted)
Mechanical
| Weight | 50 g |
Description
Note - PM06D is supported by PX4. For Ardupilot, it is supported in version 4.4 and later. - This PM uses I2C digital signal data output and is not compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers. PM06D provides a regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6-pin cable. It has built-in power distribution, allowing you to power your ESC and FC with the same board. The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with an XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact. Specification Input voltage: 2S- 14S PCB Cont. Current Rating: 70A PCB Burst Current Rating: 120A (<60 Sec) Max current sensing: 327A Voltage and current monitor with I2C compatible interface Connector Outputs: 5.2V and 3A max Weight: 24.5g Current Rating: The PM06D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. You can refer to this chart as a reference. PX4 Parameter Setup: If you are using the PM06D 14S version, you must set SENS_EN_INA228 to enable it. Pinout Package Includes： 1x PM06D Power Module 1x 6-pin 2.00mm pitch cable
