holybroHolybro
PM02 V3 Power Module (12S)
Manufacturer part no. 15010
$18.99≈ 16.46 €
Price summary
Listed by holybro at €16.46. Delivered to France, including shipping, VAT and any customs duty, it comes to about €37.75. Prices last checked on 2026-09-16.
Delivered cost is an estimate for a single item shipped to mainland France; the seller's checkout is authoritative.
In stock
Estimated landed cost
| Item | €16.46 |
|---|---|
| Shipping | €15.00 |
| VAT (20%) | €6.29 |
| Total delivered | €37.75 |
Estimate for a single item delivered to mainland France, shipped from outside the EU: customs duty and clearance fees may apply and are charged by the carrier.
Specifications (automatically extracted)
Mechanical
| Weight | 80 g |
Description
Description:This PM02 Power Module provides a simple way to supply regulated 5.2V to flight controller from the battery while providing current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable. It comes with pre-soldered wires, capacitor, and XT60 connector on both ends, along with shrink tubing on the PCBA for physical protection. Specification: Input Voltage: 2S-12S PCB Cont. Current Rating: 60A PCB Burst Current Rating: 100A (<60 Sec) Max Current Sensing: 120A Output: DC 5.2V & 3A Max Voltage Divider: 18.182 Amperes per Volt: 36.364 Weight: 20g Please Note: - The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference. - This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D). Package Includes： - 1x Power Module with XT60 Connectors Board (pre-soldered)- 1x Electrolytic capacito: 220uF 63V (pre-soldered)- 1x Molex 6 Position Connector 15 cm- 1x JST GH 6 Position Connector 15 cm Setup guide for PX4 & Ardupilot can be found in the Holybro Doc here.
