betafpvBetaFPV· Motor control
F4 Brushless Flight Controller and ESC (BLHeli_32)
Manufacturer part no. 00313308
$19.99$28.99−31 %≈ 17.32 €
Price summary
Listed by betafpv at €17.32. Delivered to France, including shipping, VAT and any customs duty, it comes to about €38.78. Prices last checked on 2026-09-16.
Delivered cost is an estimate for a single item shipped to mainland France; the seller's checkout is authoritative.
Availability unknown
Estimated landed cost
| Item | €17.32 |
|---|---|
| Shipping | €15.00 |
| VAT (20%) | €6.46 |
| Total delivered | €38.78 |
Estimate for a single item delivered to mainland France, shipped from outside the EU: customs duty and clearance fees may apply and are charged by the carrier.
Specifications (automatically extracted)
Mechanical
| Weight | 50 g |
Description
Note: DO NOT POWER WITH 4S BATTERY. This original BLHeli_32 16A ESC is out of stock, PLZ click here to choose the upgrade version. BLHeli_32 is the 3rd generation ESC firmware after BLHeli and BLHeli_S, which is written for ESC‘s that utilize 32-bit MCU. With the increase in processing power, faster input signals with lower latency and higher update rate would be possible in BLHeli_32, such as Dshot1200! Know more about BLHeli_32 ESC from Oscarliang's blog. Check out Joshua Bardwell's video to know every detail of BLHeli_32 SPECIFICATIONS OF FC The F4 FC board is the same one on Beta75X drone. Click here for more detail information about the FC board. CPU: STM32F405 (Overclock to 240MHz) Six-Axis: MPU6000 Size: 26mm x 26mm, whoop mounting pattern Firmware version: Betaflight OMNIBUSF4SD (OBSD) OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode) TX02、RX02 ports is available, so that it could support TBS micro receiver RSSI ports is available Buzzer solder pads Support programable LED like WS2812 etc Weight: 2.7g SPECIFICATIONS OF ESC This ESC used to design for 4S battery. But under more extreme testing, it could only stand 2-3S voltage input. DO NOT POWER WITH 4S BATTERY. Support BLHELI_32 Support PPM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, Dshot1200 Input voltage: 2-3S lipo Cotinue current: 16A Peak current: 25A Firmware target: BETAFPV-16A-32bit MCU:STM32F051 Motor Connectors: 1.25mm header pins connector HOW TO ASSEMBLE FC & ESC Note: Please assemble the FC and the ESC as the picture shown below, otherwise the fc will be BURNT to damage. RECOMMENDED PARTS LIST Frame: Beta85X frame Motors: 1105 motors / 1103 motors with 1.5mm header pins connector Battery: 450mAh 3S battery RECOMMENDED RECEIVER CONNECTION All the ports are available on this board. So that you could connect any receiver you want on the board. For example. Frsky XM/XM+ Receiver TBS receiver DSMX receiver For the details about how to connect the receiv
