betafpvBetaFPV
F4 1-2S AIO Brushless Flight Controller
Manufacturer part no. 00313462
$39.99≈ 34.66 €
Price summary
Listed by betafpv at €34.66. Delivered to France, including shipping, VAT and any customs duty, it comes to about €59.59. Prices last checked on 2026-09-16.
Delivered cost is an estimate for a single item shipped to mainland France; the seller's checkout is authoritative.
Availability unknown
Estimated landed cost
| Item | €34.66 |
|---|---|
| Shipping | €15.00 |
| VAT (20%) | €9.93 |
| Total delivered | €59.59 |
Estimate for a single item delivered to mainland France, shipped from outside the EU: customs duty and clearance fees may apply and are charged by the carrier.
Specifications (automatically extracted)
Mechanical
| Weight | 20 g |
Description
We are sorry to announce that F4 1-2S AIO Brushless FC is discontinued and will not be available for sales anymore. We recommend you buy its great alternative F4 1S AIO FC. This AIO F4 FC is suitable for a lighter 1-2S whoop drone perfectly, like Beta65 Pro 2 or Beta75 Pro 2, etc. It is integrated with a Betaflight F411 processor FC, Betaflight OSD, SPI Frsky receiver, and 1-2S 5A ESC. So the 1-2S drone could save much weight for a faster fly experience. This FC is available for 1S whoop drones also. You need to solder JST-PH 2.0 Cable in a wires solder pad to replace the initial power cable. At the same time, you need to use higher than 12000KV motors, such as 0802 17500KV / 19500KV Motors to provide more power. SPECIFICATIONS OF FC CPU: STM32F411CEU6 (100MHZ ) Six-Axis: MPU-6000 triaxial accelerometer / triaxial gyroscope (SPI connection) Size: 26mm x 26mm, fully compatible with the all whoop drone mounting pattern, recommend the Beta65X frame and Beta75 Pro frame. Firmware version: betaflight_matekf411rx_4.0.0 (Development Version) OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode) Built-in SPI Frsky D16 protocol native receiver, compatible with almost ALL Frsky FCC radios(e.g. Taranis X9D/X9D Plus/X7) or Frsky compatible transmitter module. Not compatible with Frsky LBT protocol. Power Cable: 55mm, with 2pcs JST-PH 2.0 connector, AKA PowerWhoop connector Weight: 4.5g DIAGRAM FOR F4 2S AIO FC (FRSKY/FUTABA RX) Updated: For easier self-assembly, we added another set of 5V&GND solder pads on Frsky/Futaba FC. SPECIFICATIONS OF ESC Built-in ESC with 5A continuous and peak 6A current Power supply: 1-2S Support BLHeliSuite programmable Factory firmware: S_H_50_REV16_7.HEX Signal Support: D-shot150, D-shot300, D-shot600, Oneshot125, Multishot, PWM Status LED There are 3 LEDs on the bottom of the board to indicate the status, including Receiver LED ( Green), FC Status LED ( Red ), and FC Power LED ( Blue ). LED Status Description Receiver LED ( G
