holybroHolybro
PM06 V2 Power Module
Manufacturer part no. 15009
$16.00≈ 13.87 €
Price summary
Listed by holybro at €13.87. Delivered to France, including shipping, VAT and any customs duty, it comes to about €34.64. Prices last checked on 2026-09-16.
Delivered cost is an estimate for a single item shipped to mainland France; the seller's checkout is authoritative.
Availability unknown
Estimated landed cost
| Item | €13.87 |
|---|---|
| Shipping | €15.00 |
| VAT (20%) | €5.77 |
| Total delivered | €34.64 |
Estimate for a single item delivered to mainland France, shipped from outside the EU: customs duty and clearance fees may apply and are charged by the carrier.
Specifications (automatically extracted)
Mechanical
| Weight | 40 g |
Description
Description: This PM06 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated power distribution for 4 ESCs. It comes with pre-soldered wires, capacitor, and XT60 connector. Specifications： Input voltage (10S version): 2S-10S Input voltage (14S version): 2S-14S PCB Cont. Current Rating: 70A PCB Burst Current Rating: 120A (<60 Sec) Output: DC 5.2V & 3A Max Ouput Max Power : 18W Voltage Divider: 18.182 Amperes per Volt: 36.364 Please Note: The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference. This PM06 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM06D). Mechanical Specification: Dimensions: 35x35x5mm Mounting hole: 30.5mm*30.5mm Weight: 24g Pin Map: Setup guide for PX4 & Ardupilot can be found in the Holybro Doc here. Package Includes 1x PM06 Power Module 1x JST GHR 6pin 1.25mm pitch cable
